Archive for February, 2010

Deep Clean Your Fuel System At Ed Whitehead’s Tire Country

Tuesday, February 23rd, 2010

Having trouble with your fuel system? Bring your sedan into Ed Whitehead’s Tire Country for a check up.
965 S. 4th Ave
Yuma, Arizona 85364
928.782.1868

Today we’re talking about fuel system cleaning. The first thing to know is how important it is to have a clean fuel system. You need fuel to go, and the cleaner your fuel system, the more efficiently the fuel will burn. That means more power and better fuel economy.

A clean fuel system saves money at the pump. We guess you could say, it all starts and ends at the pump. One of the most important things you can do to keep your fuel system clean is to buy good quality gas. Major brands have detergents that keep gum and varnish from rapidly building up in the fuel system.

So buying cheaper gas can actually cost you in the long run. Now, most cars on the road are more than five or six years old. That means they’ve had time for some dirt and rust to start accumulating in the fuel tank. This junk needs to be filtered out of the fuel before it hits your engine. That’s the fuel filter’s job.

When the fuel filter is clogged, the dirty fuel will bypass the filter and go on up to the engine where it can clog fuel injectors and get into the cylinders. That could do some damage. So you should have your fuel filter changed when recommended. Check your owner’s manual or ask your service advisor if your fuel filter is due for replacement.

The fuel then goes up into the throttle body. This is another area where varnish and gum can accumulate. A professional fuel system cleaning will use a combination of special cleaning chemicals and old fashioned swabbing to clean out the throttle body. Now, the fuel injectors are the last stop in the fuel delivery system.

It’s real important to keep those fuel injectors clean. The fuel injectors need to deliver a precise amount of fuel, at exactly the right time, in a particular spray pattern. They just can’t do that if they’re dirty. Dirty fuel injectors really rob power and waste fuel.

It is important for the fuel system proper, but there are a couple other things that will help keep your engine clean as well. Of course, air is mixed with the fuel before it’s burned. Dirty air means dirt gets into your engine, so you need to replace your engine air filter when it’s dirty.

The PCV value routes unburned fuel that escapes into the lower engine back up into the intake system to be burned. A sticky PCV valve needs to be replaced to make sure that system is working properly and the breather filter needs to be replaced if it’s dirty as well.

Do all these things and your engine’s air and fuel will be as clean as possible. You’ll get much better fuel economy and better power

.

Share

Maintaining Your Older Car In Yuma Arizona

Tuesday, February 16th, 2010

The government mandates a lot of equipment on cars in Yuma Arizona: emission devices and control computers, safety equipment like airbags and crash worthiness requirements. All of this is great for the Yuma Arizona motoring public, but it does add quite a bit to the price of a new car.

Because new cars are more expensive, people in the Yuma area are driving their old cars longer. The average car is now over nine years old. Two thirds of vehicles on the road in Yuma have more than 75,000 miles. As cars age, their performance drops, they have difficulty idling for long periods and are more sensitive to weather extremes. Fortunately today’s cars are up to the challenge – but they need a little help to keep on goin’.

Give Ed Whitehead’s Tire Country a call to schedule your next maintenance.
965 S. 4th Ave
Yuma, Arizona 85364
928.782.1868

Some owner’s manuals don’t specify service requirements at higher mileage. That doesn’t mean it doesn’t have to be done. In fact, it’s more important than ever to stay on top of routine maintenance for cars with more than 75,000 miles.

First, just extend regular service intervals out: for instance a service that’s recommended every 15,000 miles should be performed at 15,000, 30,000, 45,000 and 60,000 miles, and so on. Because of the additional stress older engines experience, the severe service maintenance schedule is more appropriate than the regular schedule – ask your service advisor. Watch for leaks – seals and gaskets dry out over time and don’t hold the fluids as well as they used to.

It’s also time to make sure you have a good Yuma Arizona technician. There are some services and replacements that are scheduled after you put on some clicks, like timing belts, valve train adjustments, suspension, anti-lock brake service, air bags, etc. And unexpected repairs down the road are just par for the course. Check for unusual sounds, smells or the way your car feels. These could be hints that trouble’s brewing. Better to catch it early before it turns into a costly repair.

And a regular wash and wax will help maintain your car’s appearance. One of the things you can do to really help your high mileage vehicle is to begin using high mileage formulation fluids. There are special engine oils, coolants, and transmission and power steering fluids that are formulated for cars that have a few clicks on the old odometer.

High mileage oil is designed to condition seals and gaskets, reduce wear and avoid premature burn off. Older engines are dirtier inside – and dirty engines contaminate their oil faster. High mileage oil has special additives that clean the engine, removing sludge deposits over time. The result is less stress on the engine, better fuel economy and excellent wear protection.

Studies have even shown that using high mileage fluids early will actually prevent some of the problems of high mileage vehicles. So once you hit around 50,000 miles, consider stepping up to high mileage formulations. High mileage fluids cost a bit more than standard fluids because of the additional additives, but they can be worth their weight in gold in terms of preventing repair costs down the road. It does cost more to properly maintain a higher mileage vehicle – but it’s way cheaper than a new car payment!

Share

The Harm In Skipping An Oil Change For Yuma Drivers

Friday, February 12th, 2010

People in Yuma have been hearing a lot about higher oil change intervals these days. Maybe you’re wondering: What are the key issues?

Some new vehicle manufacturers in Yuma are now recommending much higher oil change intervals than they have in the past. As much as 5,000 to 8,000 miles or more. This practice came under scrutiny when four of the largest new car manufacturers announced that owners like those in Yuma were experiencing engine damage resulting from these higher oil change intervals.

The manufacturers’ standard oil drain service for particular vehicles was scheduled at around 7,500 miles. People following these recommendations were experiencing engine damage. It turns out that oil sludge was building up. This caused small oil passages to clog and engine parts to fail.

What causes oil sludge? It’s a factor of time and mileage. There are hot spots in every engine that cause oil burn off that leads to sludge. Also, water from normal condensation can build up in the oil. This water also creates sludge. Severe driving conditions lead to more rapid sludge formation.

Visit Ed Whitehead’s Tire Country in Yuma, Arizona 85364

Severe driving around Yuma includes short trips under four miles or trips under ten miles in freezing conditions. The engine just doesn’t get warm enough for the water in the oil to evaporate.

Severe conditions are at the heart of the problem. Stop-and-go driving, towing, dusty conditions, heavy loads, very hot or very cold temperatures, a car top carrier – these are all conditions that would suggest that the severe service schedule should be considered.

The severe service schedule has much shorter oil change intervals. People in Yuma just need to honestly evaluate how they drive to determine if they should change their oil closer to the severe service schedule, or to the standard schedule.

Some types of sedan will give oil change reminders. But it’s important to know how that reminder is determined. For some, the reminder simply comes when the standard mileage interval has rolled around. Others use a computer algorithm that takes into consideration the number of cold starts, trip length, engine temperature and so on. It’s programmed to approximate where on the standard/severe service spectrum you fall. Some more expensive vehicles actually have sensors that test the cleanliness and effectiveness of the oil.

For the rest of us, better safe than sorry should be the guiding principle. Talk with your Yuma service advisor at Ed Whitehead’s Tire Country and work it out together. Find out what kind of oil the factory sends out in your vehicle. Sometimes it’s a premium grade that costs more than standard oil – but it may be what’s needed to meet a higher factory recommended interval.

If you’re realistically conservative, standard grades of oil will take care of you year after year. If you want to push the limits, ask for a premium grade oil to give you extra protection.

So, what happened with those manufacturers with the problems from higher oil change intervals? They ended up extending the engine warranty for parts that were affected by oil sludge. But they had a stipulation – they lowered the oil change interval and the vehicle owner had to provide proof of oil changes at the new lower interval to keep the extended warranty.

Share

When Are Your Tires Worn Out?

Wednesday, February 3rd, 2010

Hey Yuma, are your tires worn out? What is the standard for our Arizona streets? How can you tell on your sedan?

While there may be legal requirements for the Yuma area, there are safety concerns that go beyond meeting minimum replacement mandates.

2/32 is the depth of the tire tread wear indicator bars that US law has required to be molded across all tires since August 1, 1968. When tires are worn so that this bar is visible, there’s just 2/32 of an inch – 1.6 millimeters – of tread left. It’s that level of wear that’s been called into question recently.

We’re referring to the Consumer Reports call to consider replacing tires when tread reaches 4/32 of an inch, or 3.2 millimeters. And the recommendation is backed by some very compelling studies.

The issue is braking on wet surfaces in and around Yuma. Most of us think of our brakes doing most of the work, but if you don’t have enough tread on your tires, the brakes can’t do their job. When it’s wet or snowy, the tread of the tire is even more critical to stopping power.

Picture this: you’re driving over a water covered stretch of road near Yuma, Arizona. Your tires must be in contact with the road in order to stop. That means that the tire has to move the water away from the tire so that the tire is actually contacting the road and not floating on a thin film of water.

Floating on the surface of water is called hydroplaning. So if there’s not enough tread depth on a tire, it can’t move the water out of the way and you start to hydroplane.

In the study a section of a test track was flooded with a thin layer of water. If you laid a dime on the track, the water would be deep enough to surround the coin, but not enough to cover it.

A car and a full-sized pick-up were brought up to 70 miles per hour, or 112 kilometers an hour and then made a hard stop in the wet test area. Stopping distance and time were measured for three different tire depths:

  • New tire tread depth
  • 4/32 of an inch
  • 2/32 of an inch

So what happened with the 2/32 tires on the car? Get this – when the car had traveled the distance required to stop with new tires, it was still going 55 miles an hour. Stopping distance was nearly doubled to 379 feet and it took 5.9 seconds.

Wow! That means if you barely have room to stop with new tires, you would hit the car in front of you at 55 miles an hour with the worn tires.

Now, with the partially worn tires – at 4/32 of an inch – the car was still going at 45 miles an hour at the point where new tires brought the car to a halt. It took nearly 100 feet more room to stop and 1.2 seconds longer. That’s a big improvement. We can see why Consumer Reports and others are calling for a new standard.

Of course, stopping distances were greater for the heavier pick-up truck.

How do you know when your tires are at 4/32 of an inch? Easy; just insert a quarter into the tread. Put it in upside down. If the tread doesn’t cover George Washington’s hairline, it’s time to replace your tires. With a Canadian quarter, the tread should cover the numbers in the year stamp.

You may remember doing that with pennies. A penny gives you 2/32 to Abraham Lincoln’s head. The quarter is the new recommendation – 4/32.

How do people feel about replacing their tires earlier? Well, tires are a big ticket item and most people want to get the most wear out of them that they can. But do you want that much more risk just to run your tires until they are legally worn out?

For us, and we would guess for many, the answer is “no”.

Ed Whitehead’s Tire Country
965 S. 4th Ave
Yuma, Arizona 85364
928.782.1868

Share